Pumpkin in peanut sauce

Choose firm-fleshed pumpkin, dilute and simmer peanut paste first, then add pumpkin according to its tenderness. Stir gently to retain pieces. No bouillon cube or animal protein is required.

Pumpkin in peanut sauce

Ingredients

  • 900 g pumpkin flesh
  • 130 g plain unsweetened peanut paste
  • 350 g chopped tomato
  • 180 g peeled onion
  • 10 g peeled garlic
  • 15 ml vegetable oil
  • 700 ml drinking water
  • 3 g fine salt
  • 3 g mild or hot chilli to taste

Preparation

Soften onion and garlic in oil. Add tomatoes and chilli and reduce 10 minutes. Dilute peanut paste in some of the measured 700 ml water; add with the remainder.

Simmer 15 minutes, scraping the bottom. Add cubed pumpkin and cook gently 15-20 minutes until tender, adjusting to its variety.

Keep pieces visible and do not beat the sauce. Adjust salt and consistency at serving. Any rice or fonio served alongside is not included in the sauce quantities.

Introduction

A firm-fleshed squash will hold its shape in the sauce. Thin the peanut paste, cook it gently and then add the squash, allowing for how firm the flesh is. Avoid stirring vigorously near the end. This plant-based sauce is flavourful without stock cubes or added animal protein.

Prepare the squash according to the firmness of its flesh Weigh the flesh after removing the skin, seeds and thick fibres. Cut it into evenly sized cubes. If you have several pieces of squash, compare their firmness with a knife. Cubes from dense areas may need a little longer to cook. You can cut those slightly smaller so all the pieces become tender together. Keep the squash separate while making the sauce. Prepare the onion, garlic and chilli before heating the oil. Measure 700 ml of water and set aside some to thin the peanut paste. Getting everything ready helps you make a smooth sauce first, then watch the squash as it cooks without leaving clumps of peanut paste on the bottom.

Thin the peanut paste and make the tomato base Stir the peanut paste if oil is visible on the surface. Weigh 130 g and put it into a bowl. Add a little of the measured water and stir with a spoon until smooth. Add water a little at a time until the paste can be poured. Soften the onion and garlic in the oil, then add the tomato and chilli. Reduce for the stated time. Draw the spatula across the bottom to check that the tomato pulp has begun to thicken before pouring in the diluted peanut paste. Add the rest of the water. Stir along the bottom to distribute the peanut paste, then bring the sauce back to a gentle simmer. Avoid a vigorous boil, which can thicken the sauce at the bottom quickly.

Watch the sauce during the first simmer Let the sauce simmer before adding the squash. Stir into the corners and along the bottom. If you see thicker areas, pull them into the middle to spread them through the sauce. At the end of this first simmer, check that the sauce is loose enough to surround the cubes. Add the squash once the sauce runs off a spoon but leaves a thin coating. Distribute the pieces through the sauce. If the pan is tall, lift those at the bottom so the liquid can also flow between the pieces on top. Reduce the heat as the first bubbles return. The squash will soften in the sauce and may release more or less moisture depending on the variety.

Check tenderness without stirring hard Pierce one of the largest cubes around the suggested cooking time. If the centre still resists, continue cooking gently. If its edges are already very soft, check some smaller pieces too. Once the squash is almost ready, stir only by gently lifting the pieces. You can tilt the pan a little to move the sauce around. When the knife tip goes through the centre of a large cube and the pieces still hold their shape, taste the sauce with a little squash. Adjust the salt then. If the sauce is too thick to ladle, add a little hot water and bring it briefly back to a simmer. If it is very runny and the squash is fragile, take out a few cubes while you reduce the sauce, then return them to heat through.

Plate the dish and set aside any remaining portions Use a broad spoon to divide the squash between plates and pour the sauce between the cubes. If serving rice or fonio, cook the grains separately and add the desired amount of sauce beside each portion. Mention the peanuts if you set the dish on a table with other sauces. To save a portion, cool it quickly in a shallow container and refrigerate it. Reheat the sauce and pieces thoroughly. Stir along the bottom and check the centre of a large cube. Peanut sauce may thicken in the refrigerator, so add a little water if the bottom begins to dry before the portion is hot. Taste again after adjusting it. To keep the cubes intact, transfer them first and add the reheated sauce afterwards.

Adjust the cooking to the pan For a small batch, choose a pan where the liquid covers the bottom and surrounds the cubes without crowding them. A very wide frying pan speeds evaporation. A narrower saucepan keeps the liquid around the pieces but requires checking the ones on top. Either way, test a cube from the middle, rather than one that has heated near the edge. This will tell you whether to cook a little longer, add some water or make the final seasoning adjustment.

Scrape along the bottom and sides Run the spoon along the sides and bottom as you stir, where denser ingredients tend to settle. Taste a spoonful after mixing before adjusting the salt or chilli.

Tips

Simmer the diluted peanut paste before adding pumpkin. Coat the tender cubes gently and check the largest piece before serving.