Black-eyed pea fritters
Cold-soak peeled peas, then blend with very little water. A thick beaten paste makes better fritters than a runny one. Frying-bath oil is not all consumed, so no arbitrary nutrition estimate is supplied.
Ingredients
- 300 g dry peeled black-eyed peas
- 120 g peeled onion
- 100 ml drinking water
- 3 g mild or hot chilli to taste
- 3 g fine salt
- 700 ml vegetable oil
Preparation
Soak peeled black-eyed peas in sufficient drinking water in the refrigerator for about 8 hours, in addition to active preparation time. Drain and rinse.
Blend with onion, chilli and the 100 ml water, added gradually, into a thick, soft paste. Add salt and beat for a few minutes to aerate.
Heat frying oil in a stable pan to about 170-175 °C. Fry small spoonfuls in batches for 4-6 minutes, turning until golden and cooked inside. Open the first fritter to check. Drain and serve hot. The oil bath is not all consumed; never add water to hot oil.
Introduction
Hulled black-eyed peas are soaked in the refrigerator, then blended with very little water. Runny batter disperses in the oil, whereas a pliable, whipped batter makes lighter fritters. The stated amount of oil is for the frying bath and is only partly consumed, so it does not provide a basis for an arbitrary nutrition calculation.
Plan the soak and draining Measure the dry hulled peas before soaking. Choose a container large enough for them to swell and cover them with drinking water. Refrigerate for the time specified. When you are ready to make the batter, discard this water, rinse the peas and drain in a colander. Measure the 100 ml of blending water separately. If a lot of rinse water clings to the peas, the batter may turn loose even before you add the measured liquid. Once drained, shake the colander gently and check that almost no water runs out. Set the onion and chilli near the blender so you can adjust the batter while the peas are still cold.
Blend to the right consistency Chop the onion. If the blender is too small for the whole mixture, add some of the peas and aromatics at a time. Pour in a little water to start and pulse briefly. Stop the motor before scraping down the sides. Add water only a little at a time so the batter remains thick enough to mound on a spoon. If you blend in batches, combine them in a bowl before adding salt. Stir to distribute the water and aromatics, then whisk to incorporate air. A spoonful should slide off in one soft mound when pushed with a second spoon.
Heat the oil and fry a test piece Choose a stable, deep pan with plenty of room above the oil. Set it on a burner that suits the base and turn the handle away from foot traffic. Keep a rack or a plate lined with absorbent paper nearby. Heat the oil to around 170 to 175 °C. Lower a small spoonful gently just above the surface. Cook this first fritter, remove it and split it open to check the middle. If the outside colours too quickly and the inside is still doughy, lower the heat a little or make smaller portions. Wait for the oil to return to the desired temperature before continuing.
Keep the batches even Scoop portions of similar size and leave space between them in the oil so they can be turned. If the first spoonfuls touch as they puff up, fry fewer pieces in the next batch. The oil cools when you add batter. Let it heat back up between batches and keep the heat steady without turning it up abruptly. Turn the fritters once the first side has set, then check that both sides are golden. Split another fritter to check it if you change the size or if the oil has cooled substantially. Drain in a single layer. Stacking the fritters straight away traps steam and may soften their crust.
Serve while the crust is crisp If serving several people, put the first drained fritters on a serving dish and continue frying. Lay out the serving spoons in advance to keep work around the hot oil simple. If offering a condiment, serve it on the side so people can take some without wetting the whole batch. The stated oil quantity is for the bath. After frying, turn off the heat and let the pan cool on a stable surface before handling the oil. Keep unused batter away from the pan so no liquid spills into the oil. Cool leftover fritters quickly and refrigerate them, then reheat thoroughly any portions you intend to serve.
Adjust the batter after the first batch Look at the bottom of the bowl as you scoop the last portions. If liquid has separated, stir gently to redistribute it before continuing. Batter that flattens as soon as it reaches the oil may contain too much water. Start with less water when blending, then check the first fritter before thinning the rest. If the batter is too stiff to slide easily off the spoon, work it with the spoon and add a little of the remaining measured water. Check that the fritters cook through after every change in size or consistency.
Tips
Add the measured water gradually. Open the first small fritter to check its centre and lower the heat slightly if the outside browns too soon.
