Cowpeas with ground peanuts
Tender cowpeas gently coated in ground roasted peanuts.
Ingredients
- Dry food-grade cowpeas 350 g
- Unsalted roasted peanuts, finely ground, 100 g
- Salt 3 g
- Soaking water 1.5 litres, discarded
- Initial fresh cooking water 1.5 litres
- Hot reserve water 200–400 ml if needed
Preparation
Sort and rinse cowpeas; soak 8 hours refrigerated in 1.5 litres water, then discard water.
Boil in 1.5 litres fresh water for 10 minutes, then simmer 35–60 minutes or longer until tender, topping up if needed.
Check several cooled beans have no chalky centre; retain about 120 ml free liquid and remove excess.
Scatter peanut powder on top, cover and heat very gently 10 minutes without initially stirring.
Add salt, fold gently and simmer 10–15 minutes, adding spoonfuls of hot water if dry, without crushing beans.
Rest covered off heat 5 minutes and serve four coated, moist portions with separately prepared accompaniments.
Introduction
Tender cowpeas gently coated in ground roasted peanuts. This adaptation omits potash and uses roasted peanuts; it is a documented enrichment variant of a cowpea base.
Cultural context
This preparation is documented in the Burkinabe Ministry of Agriculture booklet. These measured quantities and methods are a household adaptation, not an exact reproduction or a claimed kitchen test. Source: https://nutrition.bf/sites/default/files/2024-01/livret-mets-locaux-volume-2.pdf#page=18
Tips
This adaptation omits potash and uses roasted peanuts; it is a documented enrichment variant of a cowpea base.
Variations
Tomato sauce, fish or meat can be served separately and must be described independently.
Accompaniments
Cooked carrots, cabbage or leaves.
Nutrition notes
Theoretical estimates per serving (one quarter of the recipe), calculated using FAO/INFOODS Western Africa 2019 and Anses Ciqual 2025. These are not laboratory results. Measured edible ingredients and all added fat are counted; actual cooking and serving losses may change the result. ND means undetermined, never zero. Total salt = sodium × 2.5, only where data coverage and retention allow calculation. Vitamins and other minerals are not quantified. Branded products and local varieties may differ from the generic references. Flours and semolina are modelled using the corresponding dry cereals or pulses; milling and refining can change composition.
